Home
Performance
Displacement
Cubic Inches/Revolution
10.0
6.0
3.0
Speed
Revolutions/Gallon
Max. Continuous RPM (recommended)
Normal Min. Smooth RPM (metering-out flow control)
Absolute Min. Smooth RPM (metering-out flow control*)
23.1
460
5
<1
38.5
770
15
5
77.0
1540
20
15
Flow Max. Continuous GPM (recommended)
Case Drain GPM - Zero Load (1000 PSIG)
Case Drain GPM - Full Load (1000 PSIG)
20
0.05
0.30
20
0.05
0.30
20
0.05
0.30
Approx. 5 GPM Produces Highest Overall Operating Efficiency
Torque Theoretical lb-in.100 PSID
Max. Continuous lb-in (a 1250 PSID
Max. Starting lb-in (a 1250 PSID
159.2
1592
1313
95.5
955
776
47.7
477
328
For starting Torque at other presures, Refer to Graph
Pressure Max. Continuous PSI (recommended)
Max. Working Pressure Ports A & B (PSIG)
Max. Backpressure above Drain Pressure (PSID)
Max. Drain Pressure above Ambient (PSIG)
Min. Drain Pressure above Ambient (PSIG)
1250
2000
25
75
5
1250
2000
45
75
5
1250
2000
65
75
5























* Absolute Min. Smooth RPM can be obtained with correct selection of valves and circuit design. Valves should be mounted directly to back of motor.

Allowable Radial Load (a Shaft key)
Speed - RPM
Load - LBS
50
1350
100
750
250
300
450
165
750
100
1000
75
1250
60
1500
50


Other displacement models are available. Consult Factory for specifications.

Any good quality petroleum fluid with anti-wear additives is recommended. Use higher viscosity for low speed operation. Any fluid compatible with nylon and Buna N (or Viton) and non-corrosive to steel and aluminium is acceptable under normal conditions. High Water Base Fluids (HWBF) are not recommended for general use in Nutron Motors. Consult factory for further information.





Ordering Information
Typical Model Code: BV - 6 - S6B - MK6 - V - SF


Type:
BV - Valve model for meter out speed control
BVN - Nickel plated for corrosion ressitance
BVE - Encoder model, specify number of pulses

Displacement:
3 - 3 in3/rev
4.5 - 4.5 in3/rev
6 - 6 in3/rev
8 - 8 in3/rev
10 - 10 in3/rev

Shaft:
No Designation - Standrd 1" dia shaft with 1/4" key
R - 5/16" dia reamed tailshaft socket in standard 1" dia shaft
S6B - 6 tooth spline
S13B - 13 tooth SAE "B" spline
M - 25mm dai shaft with 8mm key

Mounting Style:
No Designation - Standard face plate mount or bracket mount
MK6 - 2 special bolts factory installed for direct SAE B 2-Bolt flange mount ONLY
SM6 - 2 standard SHCS 1/2-13x6"

No Designation - Buna N
V - Viton seals
SF - Absolute min. smooth

Note:
  • Fluid used must be compatible with nylon.
  • All motors (Including viton seals option) have parts made of nylon.